Land Pride PD25

Double tap to zoom

Features	Benefits
Cat. 1 or 2 Hitch	Fits a wider variety of tractors by fitting Cat. 1 & 2
2 7/8" Yoke	3/16"+ Wall thickness for strength
3 1/2" Reinforced boom	7/32" Wall with 3/8" x 2" bar for strength
Auger flighting	Constant thickness on 1/4" flighting vs. tapered.
Replaceable hardened steel points on auger	Hardened points will last longer than non-hardened. Points can easily be replaced when worn or damaged. Cast steel auger fishtail tips.
Gearbox HP rating	25 Series: 25-55 HP and 35 Series: 30-75 HP.
2" Output shaft	Fits most other auger manufacturers for users who don’t need a new auger
Cat. 3 driveline with shear-pin or optional radial pin clutch	Protection against obstructions. Radial pin works like a ‘ratchet’ to continually put driving force on the auger in tough conditions.
Large selection of augers	Variety of Dirt Auger and Rock Auger sizes and styles to suit many applications.
Large selection of Bolt-on Rock Heads (accessory)	All sizes of Land Pride PD25 and PD35 Pengo Dirt Augers can be converted to Rock Augers with this accessory.
Alignment handle (optional)	Guide the auger from the tractor seat.
Down pressure kit (optional)	Allows additional force to be supplied, hydraulically, to the beam to help force digger into the ground.
Post Hole Digger stand (optional)	Bracket mounted to bottom of gearbox can incorporate a Post Hole Digger stand. This allows operator to hook up and unhook from tractor more safely. Stand supports unit and will store unit when it is not on the tractor.

Model	PD25
Tractor HP Range	25 to 55 HP
Weight Without Auger	186 lbs
Auger Length	48"
Auger Flight Thickness	1/4"
Auger Pipe	2 1/2" ID
Auger Teeth	Forged, Individually Replaceable; 40 Degree angle installed on flat side; 50 Degree angle installed on angled side
Number of Teeth	(6" - 2 teeth) (9" & 12" - 4 teeth) (15" - 5 teeth) (18" - 6 teeth) (24" - 8 teeth)
Pilot	Cast Steel, 3 Drill points
Driveline Cat.	Cat. III Shear bolt - Standard; Cat. III Radial pin clutch - Optional (Recommended on Auger Sizes 15" and above.)
Maximum Operating PTO Speed	300 RPM
Gearbox	1 3/8" 6B spline input shaft, 3.18:1 Ratio
Gearbox Oil Capacity & Type	4.6 Pints of SAE80-90W EP oil
Output Shaft	2" O.D. Round
3-Point Hitch Cat.	Cat. I & II
Boom	3 1/2" O.D
Yoke	2 7/8" O.D.