Grasshopper 432 / NOT AVAILABLE

Double tap to zoom

 

Features

Hydraulic Height Adjustment

  • Hydraulic Height Adjustment for MidMount DuraMax™ decks 61-inches and larger allows operators to raise and lower cutting height at infinitely variable settings with toggle switch control. Standard on 400 Series models.

 

Reduced Maintenance

  • Only two Access-Eze™ lubrication points cut maintenance time up to 95%
  • Self-tensioning belts minimize cost and labor on routine maintenance

 

Heavy-duty Deck

  • Extra-deep, 5.5-inch deck is fabricated from heavy-gauge formed steel with a reinforced anvil edge
  • Specially designed cutting chambers enhance airflow for better cut quality
  • Deck easily converts from side discharge to optional Down Discharge™ mulching or PowerVac™ collection
  • Sentry™ spindles with massive, 8-inch flanges anchored in a 6-bolt pattern, spread the force of impact for greater strength
  • Spindle planes are fabricated from double-layered formed steel laminate and combine with the spindles to form a triple-strength deck to keep blades level and deliver a high-quality cut.
  • Sentry™ spindle guards shield spindle housing and seal lower bearings from fiber wrap and dirt ingestion

 

Design-Matched G2 Transmission

  • Rugged G2 transmission with auxiliary cooling fans, HydroGear variable displacement 21 cc piston-type pumps and high-torque Parker wheel motors
  • CoolFan™ hydro cooling system with 7-micron absolute filter for cooling efficiency
  • Delivers smooth response and requires less maintenance, with industry-leading 1,000-hour fluid change interval

 

Ultimate Suspension Ride® Seat

  • Deep-cushioned, high-back, foam-padded, scuff-resistant Cordura®-covered seat with padded lumbar support and armrests
  • Roomy, iso-mounted, shock-absorbing footrest

 

Minimal Maintenance

  • Fewer than 10 grease points and easy top-side access to belts and filters
  • 1,000-hour transmission fluid change intervals
  • Self-tensioning belts minimize cost and labor on routine maintenance

 

Rugged Construction

  • Robotically-welded steel construction for long-lasting durability
  • Centered-bearing design provides greater load-bearing capacity to handle the weight of operator, fuel and high-capacity collector with reserve strength for curb shocks and weight shifts
  • Tough-as-nails powder-coated finish is fusion-bonded for chip and rust resistance

 

Vigilant Operator Presence System™

  • Standard, low profile Roll-over Protection System (ROPS) structure with an adjustable seatbelt
  • Dampened steering levers that return to neutral from forward and reverse
  • Interlock switches that shut down the engine when the operator leaves the seat while PTO is engaged or levers are in drive position

 

Ultimate Operator Station®

  • ComfortZone™ seat eliminates jostles and jolts with coil-spring suspension and a fully padded, high-back seat, padded armrests and variable density foam cushion. Iso-mounting smooths the ride, erases fatigue and keeps the operator comfortably in control at faster mowing speeds
  • Operational controls including throttle, choke and angled View-Eze™ console and adjustable cup holder are well positioned for visibility and ease of reach
  • One- or two-handed operation with ComfortReach™ adjustable Hydra-Smooth™ dual levers that automatically return to neutral from either forward or reverse position.

 

High Temperature Clutch Cut Out

  • Equipped with a High Temperature Clutch Cut-Out that automatically disengages the PTO if engine temperature reaches a certain point to prevent engine damage

 

Kubota MaxTorque™ Gasoline

  • 962 cc, 3-cylinder, liquid-cooled Kubota MaxTorque™ gasoline engine with horizontal crankshaft and pressure lube for smooth, reliable operation

Specifications

Specifications Model 432-61 & 432-72
ENGINE  
Type/Horsepower/Cylinders Kubota, 3-cyl.
Displacement 58.7 cu. in. (962 cc)
Lubrication System Pressure Lube/Filter
Crankshaft Horizontal
Cooling System Liquid
Fuel Gasoline - unleaded
Fuel Capacity 12 U.S. Gal. (45.4 l)
Optional Fuel Capacity NA
Air Cleaner Heavy-duty, cyclonic, remote mounted with replaceable dual elements and filter minder.
Muffler Ultra quiet, single, industrial type
DURAMAX® DECKS  
DECK DuraMax
Mulching Package # 504569(61), 504571(72)
DURAMAX®; DECK SIZE  
– 41" Deck NA
– 44" Deck NA
– 48" Deck NA
– 52" Deck NA
– 61" Deck *
– 72" Deck *
CUTTING HEIGHT RANGE 1.0 to 5.0 in. (2.5cm to 12.7 cm)
CONSTRUCTION (Robotic-welded steel) Double-layered 10-gauge plus 7-gauge formed-steel laminated spindle plane 0.313 in (7.95 mm) thick- more than 25% thicker than 0.25 in. (6.35 mm) ñ with 7-gauge skirts for geometric strength. Spindle plane is 0.9 in.(22.86 mm) thick in stress zones. Anvil-edge design with 0.5 in. (12.7 mm) reinforcement on front edge of deck.
BLADES (Tempered, alloy steel)  
– 41" Deck NA
– 44" Deck NA
– 48" Deck NA
– 52" Deck NA
– 61" Deck (3) 21 in. (53.3 cm)
– 72" Deck (3) 25 in. (63.5 cm)
SPINDLE ASSEMBLIES Sentryô Spindle System, 2.5 cm (approx. 1 in.) O.D. shaft. Double bearings greasable from top of deck. Spindle head designed to eliminate fiber wrap. Spindle cones shield housing and lower bearings from fiber wrap and dirt ingestion.
SPINDLE HOUSINGS 8 in. (20.3 cm)-diameter housing. Machined aluminum housing on 61-inch deck. Cast iron on 72-inch deck.
BLADE DRIVE Belt drive with single Kevlar V-belt and idler arm tensioning.
TRIMABILITY (Outside of std. tire to left trim side)  
– 41" Deck NA
– 44" Deck NA
– 48" Deck NA
– 52" Deck NA
– 61" Deck NA
– 72" Deck NA
STARTER & ELECTRICAL SYSTEM  
Battery (maintenance-free) 12 Volt
Starter Solenoid shift
Ignition Breakerless
Interlock System Prevents engine start when PTO clutch is engaged or steering levers are in drive position. Allows operator dismount without engine shutdown only when PTO is disengaged and steering levers are locked in neutral.
ULTIMATE OPERATOR STATION  
Seat Ultimate Suspension Ride (USR) iso-mounted, high-back, deep-cushioned, foam-padded, CoolTemp Cordura-covered, padded arms/backrest with lumbar support and coil-spring suspension. Optional CoolTemp Cordura-covered premier suspension seat.
Suspension InFrame™ suspension with iso-mounted seat and footrest
Console-mounted Instruments Low engine oil pressure, alternator, temperature and parking brake warning lights, engine temperature and volt gauges, digital hour meter, ignition, hydraulic height adjustment and push/pull PTO switches. Choke integrated with throttle lever.
Work Lights Optional
Hour Meter Standard
TRANSMISSION & STEERING  
Type Design-matched G2 hydrostatic system with auxiliary cooling fans, HydroGear variable displacement 21 cc piston-type pumps and high-torque Parker wheel motors.
Filtration  
Speed 0 - 11 mph (0 - 17.7 kph) forward 0 - 6.0 mph (0 - 9.7 kph) reverse
Turning Radius True zero degree, turns within own length with counter-rotating, independently powered drive wheels.
Steering One- or two-hand operation with adjustable HydraSmooth™ dual levers that automatically return to neutral from either forward or reverse position.
Brakes Dynamic braking through hydrostatic transmission.
Parking Brake Disc parking brakes, one for each drive wheel.
Attachment Drive NA
TIRE SIZES  
MidMount  
Drive Wheels - Standard (4-ply rated)  
– 41" Deck NA
– 44" Deck NA
– 48" Deck NA
– 52" Deck NA
– 61" Deck 24x12.00x12 turf, 4-ply rated
– 72" Deck 24x12.00x12 turf, 4-ply rated
Drive Wheels – Optional (4-ply rated) 24x12.00x12 bar tread, 4-ply rated
Front Wheels – All Models 13x6.50x6; rib tread, pneumatic with greasable, double-sealed bearings to protect from grass wrap.
FrontMount  
Drive Wheels – Standard (4-ply rated) NA
Drive Wheels – Optional (4-ply rated) NA
Single Tail Wheel NA
Wide Stance Single Fork Tail Wheel NA
Deck Tires (4-ply rated)  
– 41" Deck NA
– 44" Deck NA
– 48" Deck NA
– 52" Deck NA
– 61" Deck NA
– 72" Deck NA
DIMENSIONS  
Height (Seat Back) 47.0 in. (119.4 cm)
Height (Seat Cushion) 31.5 in. (80.0 cm)
Height (ROPS) 69.5 in. (176.5 cm)
Length (MidMount or FrontMount w/ DuraMax Deck)  
– 41" Deck NA
(Deck in Mowing Position)  
– 44" Deck NA
– 48" Deck  
– 52" Deck NA
– 61" Deck 86.0 in. (218.4 cm)
– 72" Deck 89.5 in. (227.3 cm)
Length (FrontMount Power Unit + DuraMax Deck)  
– 44" Deck NA
(Deck Raised - Flipped)  
– 48" Deck NA
– 52" Deck NA
– 61" Deck NA
– 72" Deck NA
Deck Width (Side Discharge)  
– 41" Deck NA
– 44" Deck NA
– 48" Deck NA
– 52" Deck NA
– 61" Deck 74.5 in. (189.2 cm)
– 72" Deck 85.5 in. 227.3 cm)
Deck Width (Mulch*)  
– 41" Deck NA
– 44" Deck NA
– 48" Deck NA
– 52" Deck NA
– 61" Deck 62.5 in.* (158.8 cm)
– 72" Deck 73.5 in.* (186.7 cm)
FrontMount PowerUnit Only (Width/Length) NA
FrontMount Power Unit (Wheelbase) NA
WEIGHT - MidMount or FrontMount with DuraMax  
(Uncrated)  
– 41" Deck NA
– 44" Deck NA
– 48" Deck NA
– 52" Deck NA
– 61" Deck 1410 lbs. (639.6 kg)
– 72" Deck 1500 lbs. (680.4 kg)
FrontMount Power Unit Only (uncrated) NA
FrontMount Deck Only - Side Discharge (uncrated)  
– 41" Deck NA
– 44" Deck NA
– 48" Deck NA
– 52" Deck NA
– 61" Deck NA
– 72" Deck NA
Mulching Package  
– 41" Deck NA
– 44" Deck NA
– 48" Deck NA
– 52" Deck NA
– 61" Deck 36 lbs. (16.3 kg)
– 72" Deck 44 lbs. (20.0 kg)11
* Add 1.5 in. (3.8 cm) to width for side discharge with deflector raised.

All specifications and information displayed on this Web site are subject to change without notice.